
|
||||||
|
------------------------------------------------- |
||||||
|
|
|||||
|
------------------------------------------------- |
||||||
|
|
|||||
|
------------------------------------------------- |
||||||
|
|
|||||
|
------------------------------------------------- |
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
||||||
|
|
||||||

|
“Just one search to Find Plasterers & Compare Costs for Plastering Services inc Drylining, External Rendering, Screeding, Plaster Repair & Skimming Works Nationwide...”
Since our launch in early 2010 Plastering Supermarket have rapidly become the fastest growing Comparison Site where you find out just how much it costs for plasterers and plastering services to residential and commercial property with just a few easy clicks.
|
|
Laying a level floor screed over a large area is difficult and to do so “By eye” requires years of experience. However there is an easier way and this is where the word screed comes from.
The word screed actually means “An accurately levelled strip” of material laid on a wall or floor as a guide for the even application of a covering. So our screed is not a floor screed but a floor covering and to get the covering level we must introduce some screeds!
It’s fairly simple to lay a few screeds across a floor and level them as you go and it’s even easier if you have help laying the screeds. We will work with a 50mm covering and to lay our screeds we will use some 100 x 50mm timbers. This is a standard size timber and you only need 1. For most room sizes a timber of a standard 4.8m long is plenty and this can be cut down as required. Make sure you examine the timber before you buy it as you need a straight piece, not a piece that bows everywhere, this will make life, and your floor, very bumpy!
Mix your floor screed at 4 sand to 1 cement. The mix should be fairly dry. The way to tell if you have it right is to grab a handful of mixed screed (put your marigolds on first) and squeeze. The mix should stay in one firm lump in your hand but very little liquid, if any, should come out.
Lay the timber onto the floor, following the plan shown and place a spirit level onto the timber. If it is out of level it can be packed up using some of the mix you have in the appropriate places.
When the timber is in position, place a shovel full of the mix every 300 mm along the timber and flatten out with a plasterer’s polyurethane float. The mixed screed should be about 75mm wide.
You will see that the screed you are placing naturally falls away at an angle at the side. When you have finished each mixed screed, cut this back square to the timber screed as shown by the white cut line in the diagram below.
Remove the timber when you have finished a screed and place it in the next position. This needs to be done carefully to avoid damaging the edge of the screed and always wet the timber before laying the screed to avoid sucking moisture from the mix unnecessarily. This can be done quite simply with a paint brush and a container of water.
Leave the newly cast screeds for a day and then fill in the gaps with the same mix. Level across the screeds using your spirit level or a straight edged piece of timber, moving the mix around until it is absolutely level between your two screeds. Fill in any voids.
Rub the covering to a void free finish with the float.
Floor screeds should be cured rather than just dried out quickly. Curing in this instance means dried out slowly and a floor screed needs to retain its moisture for as long as possible. This is necessary because of the high cement content and rapid drying could lead to cracks. To cure place a polythene sheet over the screed and several days should be allowed before the surface is walked on.
|
|
If you haven’t posted an inquiry before for plasterers and would like a few more details on how the price comparison system works you should take a quick read on our FAQ’s section which explains the procedures to find plastering services and how we compare prices.
If you still need help with your plastering cost inquiry and would like to speak to a human rather than completing an inquiry form then we would be delighted to hear from you.
Just give our Customer Support Desk a call or send us an e-mail and we will be happy to phone you back.
“Just one search to Find Plasterers & Compare Costs for Plastering Services inc Drylining, External Rendering, Screeding, Plaster Repair & Skimming Works Nationwide...”
![]()
Tel: 0871 5989 529
E-mail: support[@]plastering-supermarket.com
|



Plastering Services
Post an inquiry for Plastering Services and get up to five comparative estimates from local plasterers...
Plasterers Feedback
You can view feedback for Plasterers and leave feedback for your own plastering services...
Price Comparison Tools
Use our Price Comparison tools to compare costs for plasterers and plastering services Nationwide...
A QFJ Media Website
QFJ Media Limited Reg No: 7098341 © 2005 - 2011. All rights reserved - T&C - Privacy - Disclaimer - Link To Us - Trade Register - Sitemap - Contact
Find Plasterers & Compare Costs for Plastering Services inc Drylining, External Rendering, Screeding, Plaster Repair & Skimming Works... |
Compare Costs: | Architects | Surveyors | Air Conditioning | Solar Panels | Double Glazing | Blogs |